Leica DIGITAL MODUL R Instrucciones de operaciones descargar pdf (Pagina 78)

74 / Detailed guide / Preparation

Removing the battery compartment/

an attached motor

Like the Motor-Winder-R8/R9 / Motor-Drive-R8/R9,

the power unit for the Digital-Modul-R has its own inte-

grated grip section. The battery compartment or any

motor attached must therefore be removed from the

camera.

Removing the camera back

1. Open the camera back.

2. Place slider B on the inside of the camera back, as

shown in Figure 1. For correct guidance, the grooves

in the slider must be aligned with the vertical strip to

the right of the axis (arrow).

3. Press the slider and thus the moving upper joint pin

on the back downwards. The back is thus unlocked

and can be

4. tilted (Figure 2) and removed.

To attach the camera back, follow this procedure in

reverse order.

Attaching the digital back

1. Insert the lower rigid joint pin (1.1) on the digital

back, which is held slightly diagonal for this pur-

pose, into the camera’s lower cap bearing (Figure 3).

The camera and digital back should be held at an

angle of approximately 90°.

2. Press the red slider (Cb) on the protective cover

(Ca) – and with it the moving upper joint pin – down-

wards (Figure 4),

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 118 119

Sin comentarios

Leica DIGITAL MODUL R Instrucciones de operaciones Pagina 78